OMG that is horrible! Let us all know the outcome of this!Literally dropped my black ipv4 in the toilet this morning. It wasn't on and I haven't turned bit on yet. Letting the device and batteries dry before I turn it on. How fucked am I...
Pack that bad boy in some rice for a couple days. And hope it drys everything out. Blow it out with some compressed air first.Literally dropped my black ipv4 in the toilet this morning. It wasn't on and I haven't turned bit on yet. Letting the device and batteries dry before I turn it on. How fucked am I...
Did you immediately pull the batteries? It might be okay if you open it up and let it dry thoroughly for a few days. I also heard somewhere that setting electronic devices in a paper bag and covering them in rice for a couple days will help draw out any residual moisture, but I don't have any first hand experience with it, so I don't know how much stock to put in that.Literally dropped my black ipv4 in the toilet this morning. It wasn't on and I haven't turned bit on yet. Letting the device and batteries dry before I turn it on. How fucked am I...
Literally dropped my black ipv4 in the toilet this morning. It wasn't on and I haven't turned bit on yet. Letting the device and batteries dry before I turn it on. How fucked am I...
You're going to have to tell us all if the "taste" is off after going for a swim in the dunny
Its only missing insulation tape on the charging board. Open it up there should be two.clear pieces of tape on the top left and bottom right.I just got an IPV4 black this past weekend from ShopMVG and my device was defective on arrival with the well documented "check atomizer" issue. From what I've read on other websites, there are two versions of the device with different looking internals and the one I got was the earlier version which has been known to have that check atomizer issue.
Good luck if you find one, hopefully yours is without issue!
Its only missing insulation tape on the charging board. Open it up there should be two.clear pieces of tape on the top left and bottom right.
Its only missing insulation tape on the charging board. Open it up there should be two.clear pieces of tape on the top left and bottom right.
Yeah I'll try and take pictures tomorrow I'd do it now but the mod was abducted by my brother today.
Its not a end all cure all problems but its a pretty known one that causes fried charge boards and the check Atty problem.
Damn so your issue is the mod won't read any Atty? Always says check att..
Well at least it will be easy to get a replacement or refund. I recently got the evic vt which is a other good choice.
Write a review under vendors bro.I'm still waiting for my replacement or refund from shopmvg.com. I doubt I will ever shop on that site ever again.
I really want to like the Evic VT but I can't get past that horrendous racing stripe. It's like these Chinese manufacturers think all Americans must like muscle cars and surfing. That's like me making a box mod for the Chinese with math equations all over it.