It's a good one. I've been using mine more than any other tank for the last few days. If I can give you a bit of advice, it'd be don't use too much cotton. Ever since the Profile, I've used just as much as needed. Too much and the flavor suffers. Every pre-measured cotton lace for mesh atomizers I've tried has been too big. They all use too much cotton or expect you to by using their mesh laces.
Somebody posted a slick way of setting up mesh tanks that I've been doing. I'll post the fine points below.
1. Slide the cotton through, under the arched mesh strip.
2. Cut the cotton off even with the outside of the base of the tank.
3. Fluff cotton up and separate it into two halves. There's should be a top half and a bottom half.
4. Push the top half upwards so it's out of the way. Tuck the botton half of the cotton into the wicking channel. If for some reason it's not enough, just pull some down from the top half.
5. Trim the remaining cotton. I cut it off at a 45° angle and just leave it usually.
It's the same way I set up just about all of the Mesh rebuildables I have. Thank you to whoever posted the instructions. I think it might have been
@f1r3b1rd ?