APIWATW Challenge- Closes 01/31/2019 (15 Prizes Available)

[5150sick]

Subohm tank + Hybrid Mech Mod = Boom?

 

[choderfett]

Bavarian Cream supposed to be a clear liquid.. perhaps its steeped?

https://www.flavorwest.com/water-soluble-flavoring/bavarian-cream.html

 

[5150sick]

The eliquid is zero nic not 12mg.

Edit, maybe it is 12mg.

 

[5150sick]

That build is too low for me for a single 18650.
I try to never go lower than 0.15ohms.

 

[jwill]

APIWATW #13- @MrMeowgi Edition V2

Build info-
Mod- Timekeeper 18650 Mechanical Tube mod
Atomizer- Vapresso NRG
Coil- Single @VAPEROXX Mohawk (Ni80, 3mm ID, .13ohm)
Battery- Samsung 30 Q (rewrapped as a super hero)
Cotton- Wotofo Strips
E-Liquid- 12mg ICE COLD, being switched to a more manageable Bavarian Cream


Issues-
1. FW Bavarian Cream is a flavor concentrate (Doomsday Vaper)
2. Vaporesso NRG is a subohm tank.. not rebuildable.. no RBA deck for NRG (Choderfett) + assist (Vape Fan)
3. Far too low a build for 30Q (5150 Sick)
4.

Subjective:
1.


Doing good on this one folks. Last one for issues has been alluded to but not touched. Going to be in and out today so may be a delay. Just a heads up.

 

[Vape Fan]

I wonder what RDA that is?

 

[Doomsday Vaper]

#13 is there even a protruding center pin on tank? Hard to tell with enlarged image.

 

[jwill]

#13 is there even a protruding center pin on tank? Hard to tell with enlarged image. View attachment 129613

Is that a question or an answer?

 

[Doomsday Vaper]

Is that a question or an answer?

We will call it a guess ...i suppose.

 

[jwill]

APIWATW #13- @MrMeowgi Edition V2

Build info-
Mod- Timekeeper 18650 Mechanical Tube mod
Atomizer- Vapresso NRG
Coil- Single @VAPEROXX Mohawk (Ni80, 3mm ID, .13ohm)
Battery- Samsung 30 Q (rewrapped as a super hero)
Cotton- Wotofo Strips
E-Liquid- 12mg ICE COLD, being switched to a more manageable Bavarian Cream


Issues-
1. FW Bavarian Cream is a flavor concentrate (Doomsday Vaper)
2. Vaporesso NRG is a subohm tank.. not rebuildable.. no RBA deck for NRG (Choderfett) + assist (Vape Fan)
3. Far too low a build for 30Q (5150 Sick)
4. No protruding 510 Pin (Doomsday Vaper)

Subjective:
1.


Now we just need someone to get the subjective one. Hint, it has to do with the eliquid.

 

[Vape Fan]

oops,,

 

[jwill]

View attachment 129622

That was from 12. The eliquid is actually very good.

 

[MrMeowgi]

View attachment 129622

Wrong setup. Lol so many to scroll through though

 

[~Don~]

Subjective:

12mg in a SubOhm tank... if all the parameters were safe... would be sort of rough

 

[jwill]

APIWATW #13- @MrMeowgi Edition V2

Build info-
Mod- Timekeeper 18650 Mechanical Tube mod
Atomizer- Vapresso NRG
Coil- Single @VAPEROXX Mohawk (Ni80, 3mm ID, .13ohm)
Battery- Samsung 30 Q (rewrapped as a super hero)
Cotton- Wotofo Strips
E-Liquid- 12mg ICE COLD, being switched to a more manageable Bavarian Cream


Issues-
1. FW Bavarian Cream is a flavor concentrate (Doomsday Vaper)
2. Vaporesso NRG is a subohm tank.. not rebuildable.. no RBA deck for NRG (Choderfett) + assist (Vape Fan)
3. Far too low a build for 30Q (5150 Sick)
4. No protruding 510 Pin (Doomsday Vaper)

Subjective:
1. 12mg in a SubOhm tank... if all the parameters were safe... would be sort of rough (~Don~)

Well. ~Don~ You closed this one as well so you know the drill. We get a V3 from you as well. Awesome. Next up will be @nadalama Edition. Standby for that one, it will take me a few to get it loaded.

 

[~Don~]

How many do we still have in queue? Running out of gear to manipulate since I downsized my collection lol

 

[jwill]

You should be good for a bit. We have several.

 

[~Don~]

You should be good for a bit. We have several.

Enough to last 10 days? lol

 

[jwill]

Enough to last 10 days? lol

After you submit V3, we will

 

[jwill]

APIWATW #14- @nadalama Edition




Build Info-
Vicious Ant AX1 clone RDA
Built with 8-wrap Ni80, 24ga round, 3mm ID, 0.56 ohms
Wick is cotton bacon
Wotofo Stentorian Ram mechanical squonker
Trustfire 18650 3.7V 2000mah battery
24mg Hangsen Menthol 70/30 juice


Issues-
1.
2.
3.
4.
5.

Subjective-(Always, Everything but not this time unless you just feel inclined)


Many thanks to @nadalama for submitting this challenge.

 

[~Don~]

image faults

 

[Vape Fan]

I've never trusted a battery for vaping that has fire or amp in it's name. More of a flashlight battery imo

 

[jwill]

Are the images visible now? Sorry, I had forgot to disable my VPN before loading them.

 

[Vape Fan]

Are the images visible now? Sorry, I had forgot to disable my VPN before loading them.

The atomizer doesn't look like it would perform well with 1 coil. Maybe it does. The build spec is for 1 coil.

 

[nadalama]

Are the images visible now? Sorry, I had forgot to disable my VPN before loading them.

Yes, visible now.

 

[~Don~]

for me it doesn't look like the same two coils... just how they are connected to the positive and negative looks different (Legs)

 

[Vape Fan]

Might have trouble vaping what's in that bottle.

 

[choderfett]

Vicious Ant AX1 clone RDA is supposed to be a double coils ..

Edit> maybe you can use a single but you got two sets of air flows coming from the bottom.

Adding. . This RDA shouldn’t be a squonker RDA . But rather a drip.. doesn’t come with squonk pin
(Mod listed is a squonker)

 

[Just Lil Clouds]

3mm coils might be to big for this.
For some reason I can't enlarge the pic

 

[nadalama]

Has airflow slots in the cap for either single or dual coils.

 

[MrMeowgi]

Enough to last 10 days? lol

Better tear something up man. Ha ha

 

[~Don~]

Better tear something up man. Ha ha

I submitted another one, which will raise a few eyebrows


Sent from my iPhone using Tapatalk

 

[chrisswearingen4]

APIWATW #14

Looks like coil is touching the deck.

Sent from my SM-S727VL using Tapatalk

 

[jwill]

APIWATW #14 @nadalama Edition

Build Info-
Vicious Ant AX1 clone RDA
Built with 8-wrap Ni80, 24ga round, 3mm ID, 0.56 ohms
Wick is cotton bacon
Wotofo Stentorian Ram mechanical squonker
Trustfire 18650 3.7V 2000mah battery
24mg Hangsen Menthol 70/30 juice


Issues-
1. RDA not a squonk RDA (choderfett)
2.
3.
4.
5.

Subjective-(Always, Everything but not this time unless you just feel inclined)

 

[~Don~]

Not an entry, but looks like the coil is touching the AF on the first picture, when it attaches to the negative... oddly though on the second picture its doing it also, but in a different angel...also on same said picture it looks like the positive leg is now touching the AF...and can't zoom in well enough to tell if that is wire touching the AF at the 2nd from bottom hole.

difficult to see.

Still think 2 different coils were used in both pics, for they aren't installed the same way.

And wtf is that under the juice?

MF'r used cardboard as a wick huh LOL

I swear that is as cute as a button top if he did

Ok I'm done...LURKING!

 

[Just Lil Clouds]

I'm stuck on that coil, just doesn't seem right.
Think that coil would be run better with dual batteries.

 

[choderfett]

24mg nico seems pretty high on a dripper...

 

[jwill]

I've never trusted a battery for vaping that has fire or amp in it's name. More of a flashlight battery imo

Clean this up a bit and make it an answer please

 

[jwill]

And wtf is that under the juice?

The Hangsen Menthol is strong. You get that on stuff, it sticks around. I am surprised it wasnt presented inside of something glass. Volcano Menthol burst is the same way, you can wear it as cologne.

 

[nadalama]

The thing under the HS Menthol is a Hardee's napkin, folded thicker on one side than the other, so it would tilt the bottle to where the text on the label was more legible.

Coil has to be low in the AX1 in order to not short out against the cap. It isn't touching anything it shouldn't.

 

[KingPin!]

***notice***

just a heads up folks this challenge ends during Chinese New Year break, whilst we will carry out the rolls as normal, there will be a delay from the sponsors getting back to you or shipping prizes out until at least 13th Feb

we will put this notice up again at the end

 

[OmagaWright]

***notice***

just a heads up folks this challenge ends during Chinese New Year break, whilst we will carry out the rolls as normal, there will be a delay from the sponsors getting back to you or shipping prizes out until at least 13th Feb

we will put this notice up again at the end

I wonder if anybody noticed the updated/edited prizes post. The surprise prize from Aspire is the new Tigon stick kit.

Check the prize post for details. Must be 18 or older or parents permission. Sorry no CODs. Many will enter, few will win. Not available in all states.

 

[jwill]

Before anyone goes counting prizes we should get through these challenges. As a heads up, I think we should do a super special final challenge blowout for this one and just go all out. Might be serious, might be ridiculous and might be a little bit of both.

 

[Letitia9]

I vote fun and ridiculous.

 

[Vape Fan]

APIWATW #14
Trustfire 18650 3.7V 2000mah battery

I've never trusted a battery for vaping that has fire or amp in it's name. More of a flashlight battery imo

Clean this up a bit and make it an answer please

There's quite a few reasons why I wouldn't use this in any device.
For the build challenge, I'm thinking::: that battery 14A(probably closer to 10), might produce an ok vape. But at full charge + 14A if it has it, and voltage sag, could make it unsafe for a mech. Other than the other reasons why I wouldn't use a Trustfire battery (unless it's one of those "protected" cells and that matters), that's all I have and will have to let someone with more mech experience answer the challenge on the battery.

Before anyone goes counting prizes we should get through these challenges.

Party pooper

 

[OmagaWright]

Might be serious, might be ridiculous and might be a little bit of both.

I sense the return of Da Don lol

 

[jwill]

APIWATW #14 @nadalama Edition

Build Info-
Vicious Ant AX1 clone RDA
Built with 8-wrap Ni80, 24ga round, 3mm ID, 0.56 ohms
Wick is cotton bacon
Wotofo Stentorian Ram mechanical squonker
Trustfire 18650 3.7V 2000mah battery
24mg Hangsen Menthol 70/30 juice


Issues-
1. RDA not a squonk RDA (choderfett)
2. Battery is shit. Not suitable for anything (Vape Fan)
3.
4.
5.

Subjective-(Always, Everything but not this time unless you just feel inclined)

 

[jwill]

Most of the Ultrafire/Trustfire/Dumpsterfire batteries are AAA batteries wrapped in an 18650 cell. They are garbage through and through.

 

[Troy44]

I can't tell which is which? The coil appears to be connected to either a positive & positive post or negative & negative post not one of each?

Sent from my SM-G920W8 using Tapatalk

 

[Vape Fan]

# 14
The buttom switch looks low like it wouldn't make good contact.