Become a Patron!

HELP .1 ohm coils for tesla invader

kennykoils

Member For 4 Years
Member For 3 Years
Member For 2 Years
Member For 1 Year
Title says it all, I'm picking up an invader 2 tomorrow and I'm looking for help with some .1-.15 ohm coils, prefer a quick ramp up. And yes. I know it's low, but the amp load will be split between 2 vtc4, so about 21 amps a piece gives me plenty of headroom. That being said, looking for ideas for some low ohm builds, will most likely be done on my troll mod. I usually build with 24 kanthal and or 26 ni80 on my mech but have access to a lot of wire just want some solid base/opinions for my first build in it tomorrow night :D I tried one out today with my build from my mech, parallel 24ka/26ni80 on a 3 mm bar around .17 ohm and it kicked ass but I want to go real low an get the most from my new box. Thanks in advance folks!
 

DED420

Silver Contributor
Member For 4 Years
This is still one of my all time favorite builds (it's stupid easy, and amazing flavor and vapor) Twisted 24ga Spaced 4x4 Sleeper build at 0.1ohm. Takes a second to ramp up from a cold start, but that's negligible with fresh batts. I run this build easily over 100W on my X-Cube2, or on my ABS Parallel Box, and works beautifully on both!

20151217_2104421.jpg
 

CrazyChef

Custom Hand Crafted Coils - PureCoils.com
VU Vendor
VU Donator
Platinum Contributor
Member For 4 Years
ECF Refugee
Staple coils, hands down.
 

kennykoils

Member For 4 Years
Member For 3 Years
Member For 2 Years
Member For 1 Year
Found a couple I like, quad 24 ka .12 ohm in a kennedy and fused Clapton duals, 26ni80 wrapped in 32ka in a troll .16
 

VU Sponsors

Top