When I was putting the bellus on my silver G2 that just came in. I got that no atomizer message a couple of times. The screw that on the 510 is not protruding enough to make good contact with the pin on the G2. I can't really loosen it cause it loosens the post where you put your Kanthal threw. I have to screw in a 510 heatsink into the mod. Even then it can be a little finiky. Does anyone know where you might get some of those brass or copper screws that go into the 510 from the bottom of the tank. I would sure like to have some just a hair longer.btw, it ain't easy getting to that NO ATOMIZER screen, is it? Been trying about 10 times to do that again, can never get to it. That's like hitting the G2 No atomizer jackpot. lol
For kenthal I'd suggest using kenthal mode. Setting your wattage and temp. Then going into the advanced menu and changing the kenthal curve starting low and going up till you get what you want. I used 14-18% for the tfv8 kenthal coils and it worked great. For ni80 it would be the same but set it to xxx mode. Idk what % I never used n80 wire
Sent from my SM-G935V using Tapatalk
No problemThat's what I needed.
The entire state of Vermont is run off one silver G2 in a chain link enclosure near the Canadian border.I have a Blue, Red and Black G2 and all 3 combined still don't equal the power of the Silver. I have made a conscious decision to not add the Silver, I am afraid it will suck all the life out of my other G2's just from intimidation. Lol
Thanks for that info, I will give it a tryFor anyone having trouble with their G2 not reading their attys, there's one of two things you can try. One of them should work. If you think your pin is too long, put a drip tip oring around the 510 on your atty right to the base and try that. If you think it's too short, get something to work the 510 in the mod up and down a little bit just by lightly pushing it down and letting it spring back up fast. Once you do that a few times, retry your atty.
@Jake2030
@uniman4
Ok, I have an easy question that a search of this thread didn't answer.
What value do I use for NiFe52?
SS430 has a TCR of .00138. NiFe52 (CW) has a TCR of .0034. I don't think they are anywhere near each other. NiFe52 is Nickel ~52% and Iron ~48%.Never used NiFe52 but figure try to match it to the closest material as far as the TCR is.
Here is a guideline when using the XXX mode:
I googled it and it looks like NiFe52 is about the same as SS430, if that's the case maybe try the SS 430 preset. If not then I would try and set FSK to about 10% in XXX mode and adjust from there.
Iirc I used 45-50% in xxx mode with the nife52 I got from crazy wireOk, I have an easy question that a search of this thread didn't answer.
What value do I use for NiFe52?
SS430 has a TCR of .00138. NiFe52 (CW) has a TCR of .0034. I don't think they are anywhere near each other. NiFe52 is Nickel ~52% and Iron ~48%.
Cheers,
Steve
It sure is an amazing mod isn't it?The curve worked great. At 35% it seems fairly close to the temp set.
So now I have Temp Control on my naked staple...wow.
Yes. Until I turned it down. At 500f it keeps a steady temp. 490f barely fires. Maybe 10w?It sure is an amazing mod isn't it?
Sent from my SAMSUNG-SM-N915A using Tapatalk
I have noticed the 510 seems a little weak but every rda I throw on it it works, no issues...... yet.... fingers crossed. even the slice 510 is the same, no issues.I've said this from the beginning, the 510 on the G2 is not great. Not the worst I've seen but still not good.
The spring is weak, it has an o-ring in it where it should be delrin, it's about 1.2mm too shallow, and finally the damn thing is chrome plated brass.
Come on Hohmtech, give us a 510 worthy of the board that's providing power to it. We have this milled aluminum case, the best chip on the market (IMO), and a 510 that would be embarrassed to ride on top of an eGo. I kid a bit, it's not that bad but compared to the quality of the rest of the device it almost is.
Other than the chrome starting to wear and the threads getting cut too deep I haven't physically had any issues, but there coming. Soon it will wear enough that it will strip.I have noticed the 510 seems a little weak but every rda I throw on it it works, no issues...... yet.... fingers crossed. even the slice 510 is the same, no issues.
Sent from a phone
BTW folks, man i love those minitanks, don't know why.
ANYWAYS, back to this story. Vaping on my Alien, put a different subtank on it, and the Alien won't read that now either! I have 3 subtanks, it still reads the other 2 just fine.
What is the problem with these subtanks? I am getting awfully tired of them.
Someone please give me a suggestion on a new tank to try that i can fall in love with instead.
I do know I am getting pretty darn sick of the fight.
SS430 has a TCR of .00138. NiFe52 (CW) has a TCR of .0034. I don't think they are anywhere near each other. NiFe52 is Nickel ~52% and Iron ~48%.
I have the 7ml Aromamizer Supreme , Griffin 25, and Billow V3 Plus. I have a thread on it in the appropriate section here. The Supreme is hands down the best RTA I own. The Griffin 25 and Billow V3+ sit idle on the shelf. IMO there is no comparison between the 3.The aromamizer supreme is a much better tank then the griffin 25.
The vt133 has a great 510. As does the smok alien. I'd kill for a hohmtech mod in an alien like boxOther than the chrome starting to wear and the threads getting cut too deep I haven't physically had any issues, but there coming. Soon it will wear enough that it will strip.
I don't understand why these companies don't use better 510s, the best one I have used is on the Apollo Reliant...it's deep, thick stainless with a really firm spring with no wobble due to oversized threading.
I got an ipv6x (free) a couple of days ago and the 510 on it is better than the G2, the rest of the device is meh other than the form factor.
Totally OT but I would easily pay $100+ for a G3/Slice2 in this form, it's so tiny compared to any other dual 18650 device.
Did you check the 510 on the tanks and make sure it's tight. Metal expands when hot and contracts when cold so the constant temp change causes things to loosen up in all tanks and rdas. Always a good idea to tighten and clean everything after 2 weeks of use or so.BTW folks, man i love those minitanks, don't know why. Just the ease, flavor, the way they vape, i just love em. and i have tried every other tank under the sun. Yes, i even got into building my own and all that, but that just wasn't for it. Hell, i bought this 150 made only is switzerland tank everyone local seemed to be dying for, didn't really like that one that much.
ANYWAYS, back to this story. Vaping on my Alien, put a different subtank on it, and the Alien won't read that now either! I have 3 subtanks, it still reads the other 2 just fine.
What is the problem with these subtanks? I am getting awfully tired of them.
Someone please give me a suggestion on a new tank to try that i can fall in love with instead. I would probably say the uwell crown out of all the other tanks would be my #2.
No wait, actually, the vaporesso that used the ceramic coils would be my 2, that thing was awesome, the flavor was second to none!
So what was the problem there? Well, ceramic coil after coil, I would just throw away, one after the other, could never break them in and get them to work. I almost would like to give them another shot.
Anyways, I don't know if I should blame the mods in this fight, or the supertanks. I do know I am getting pretty darn sick of the fight.
The Supreme and griffin are rebuildable. The ornate and smok tank really and clieto are good. Also you can try the eagle which is a griffin but with pre-made coilsbtw, been watching some you tube stuff, sentiment out there is that a Griffin 25 is a lot better than the Aromamizer. So maybe i will try a Griffin?
Update: Nah, i don't want to get into the build crap again, just wasn't for me. The Bachelor one I could do tho.
Freemax Starre is another tank with some stunning reviews. I think i should be able to find 4-5 tanks to begin the battle of what tank will be new and true to my heart.
Supertank, u will always be my first love, but u just couldn't stop not loving me. So many times I went back to you, so many second chances. I just can't take u back again. It's over....
lol
interesting. i used mine at around 45% IIRC but i like a warm vape so that formula sounds rightThis is from Hohmtech.
"We've make all EPT system numbers like old school TCR. Just put in TCR values for your metal of choice. If TCR is 0.0000500 (or shortened to 500), this would be = to 50.0% in EPT system (FSK Temp Curve)."
This from Steam Engiine:
TCR in vaping range
4036 ×10-6
If the CW NiFe52 is the same as the one on SE, then the value for the FSK Curve should be 40.3
It's what I'll try, as the wire vapes great on my DNA using the SE curve.
i have a gold supreme on order, can't wait till i get it to try it outI have the 7ml Aromamizer Supreme , Griffin 25, and Billow V3 Plus. I have a thread on it in the appropriate section here. The Supreme is hands down the best RTA I own. The Griffin 25 and Billow V3+ sit idle on the shelf. IMO there is no comparison between the 3.
Cheers,
Steve
Is it the new postless deck version? If so I really prefer that over my older AS with the velocity deck. You can put bigger coils in the postless version and the flavor and airflow have improved for me. The Gold looks really nice, tempted to get one but with the holidays around the corner and property taxes I should slow down on my hoardingi have a gold supreme on order, can't wait till i get it to try it out
i got the regular deck one. never had a postless one yet but i have 1 on the way arriving Saturday (conqueror) for 10 bucks i figured I'd try it out. i still prefer velocity and pharaoh style decks right now but If i like the conqueror i might grab a postless supreme as well.Is it the new postless deck version? If so I really prefer that over my older AS with the velocity deck. You can put bigger coils in the postless version and the flavor and airflow have improved for me. The Gold looks really nice, tempted to get one but with the holidays around the corner and property taxes I should slow down on my hoarding
I love variety too, a lot of really good tanks and some duds. The only Griffin I have is the Eagle I won and it is OK but with all the airlfow open it is still a little too tight a draw for me.
For tanks with prebuilt coils the Cleito 120 is real good, gives the TFV8 a run for it's money. With all this talk yesterday I put in a fresh coil into the original Cleito and it is still a very good tank, not as good as the new 120 though. The Limitless XL is a power hungry juice monger. Takes more power than all of them to really get going but is a great tank as well.
Still like my RTA'S over the prebuilt tanks but I still get a great vape out of them.
Sent from my SM-N910P using Tapatalk
He doesn't. The tanks aren't comparable.haha, that's funny then. Ck out youtube, their is this guys that specifically compares those 2, and goes on and on about how it isn't even close and what a buttkicking the aromamizer takes in comparison to the griffen. Let me find the linky, this guy must not know his stuff.
Actually, i did a little looking and I have quite a few very highly rated tanks I have yet to experience. So, I might as well slowly start working my way down this list, let me know if you favor any.
-kanger subtank mini
-joyetech cubis
-horizon tech arctic
-vaporesso gemini
-FreeMaxx Star
-SmokTech Micro TFV4
-CouncilOfVapor vengeance
-CouncilOfVapor defiant
-SteamCrave aromianizer
So yeah, I guess those ought to keep my busy for a while. REALLY looking forward to trying that COV Defiant. That might be #1 on the list. Then try to go ceramic again to see if i hit the lottery with the gemini. Finally throw in the kanger or joyetech for fun. Start out riding with those 3 for a while.
That looks wicked! Imo is way better than the whole wrapdecided my black G2 was just too damn hot to wrap it completely so removed all the wrap except for the battery door. kinda waste of $16 bucks but whatever.
Sent from a phone
thx man!That looks wicked! Imo is way better than the whole wrap
thx man!
Sent from a phone
jwrapsWhere you buy that wrap is bad ass
Sent from my iPhone using Tapatalk
This is from Hohmtech.
"We've make all EPT system numbers like old school TCR. Just put in TCR values for your metal of choice. If TCR is 0.0000500 (or shortened to 500), this would be = to 50.0% in EPT system (FSK Temp Curve)."
This from Steam Engiine:
TCR in vaping range
4036 ×10-6
If the CW NiFe52 is the same as the one on SE, then the value for the FSK Curve should be 40.3
It's what I'll try, as the wire vapes great on my DNA using the SE curve.
with fsk I guess u don't need a pc to make ur settings like dna chips. you just set your desired curve after setting the type of metal.Well, with this FSK value, I get just the vape I expected.
I can't tell a difference in the vape (amount, warmth, taste) between the G2, VT133, and Lavabox M.
I've used the same two tanks and flavors between the three mods.
Well that's a good thing, the DNA chip is really well respected, I like mine. What makes the FSK chip different though is you can adjust your vape on the fly, want it hotter, turn the fsk % up, cooler turn it down.Well, with this FSK value, I get just the vape I expected.
I can't tell a difference in the vape (amount, warmth, taste) between the G2, VT133, and Lavabox M.
I've used the same two tanks and flavors between the three mods.